Spicer Axle Housing Hardware Kit User Manual download pdf

Spicer

Axles & Brakes

P/N:SHAIS131

Installation Instruction and Torque Requirements

For Axle Housing Hardware Kit

Shown below are the torque and installation specifications for the housing axle hardware parts included in this kit. These

parts and procedures are only for the Dana models listed in the chart below.

Installation Instructions: General Fasteners

1. Block vehicle tires and disconnect driveline

2. Drain lube and remove axle shafts

3. Remove old carrier fasteners and carrier assembly

4. Before installing new fastener hardware or the carrier assembly, the axle housing should be visually inspected for

cracks, nicks or burrs on all machined surfaces. Clean the threaded bolt and stud holes in the axle housing, removing

any paint, old sealant or oil from the housing and carrier mounting surfaces.

5. Apply a bead of approved RTV sealant to the housing surface, it’s important to apply the sealant around (make a

loop) all of the threaded bolt holes. Reinstall the carrier assembly.

6. Install new fasteners supplied in kit.

7. Torque the capscrew or nut to the correct specification listed in the chart below. If installing studs be sure to install

them to the proper specification outlined below.

Important! Dana does not recommend mixing old and new carrier fasteners on the same carrier. If reusing

old fasteners, use Loctite 277 (which is red in color) on the threads of the old fastener and torque to correct

specification. Final torque values of hardware fasteners must be measured using a calibrated torque wrench.

Installation Instructions: Carrier-to-Housing Studs

Install carrier-to-housing studs into housing until 1 full thread is visible, being careful not to drive or install it too far.

The stud should extend out from the face of the housing approximately 43.5mm (1.713”).

For spec’ing or service assistance, call 1-800-621-8084 24 hours a day, 7 days a week.

Or visit our web site at: http://www.spicerparts.com

Dana Corporation

Printed in U.S.A. www.dana.com

Toledo, Ohio 43697-0321

Model Series Dana Part-No. Fastener Location Class Size lbs-ft N.m

D/R344, 404, 405, 454, DST40, 41 127567 Carrier - to - Housing Nut 12 M16x1.5 230-270 312-366

DSP/RSP40,41, RSH40, RSH44 130158 Carrier - to - Housing Capscrew 12.9 M16x2 230-270 312-366

Torque Specification Chart - (Carrier - to - Housing)

Spicer® Axles & Brakes P/N:SHAIS131 Installation Instruction and Torque Requirements For Axle Housing Hardware Kit

No comments

Spicer Axle Housing Hardware Kit User Manual