Spicer Wheel Differential Bearing Adjustment Tool Kit Ins User Manual download pdf

Spicer

Axles & Brakes

P/N: SHAIS150

Wheel Differential Bearing Adjustment Tool Kit Instructions

Shown below is a complete set of instructions on how to properly utilize Dana’s Wheel Differential Bearing

Adjustment tool. This installation tool kit is necessary to properly set up the ring gear pattern, set the

differential bearing preload and complete the installation of the wheel differential assembly. This tool kit will

allow you to align the threaded bearing cups during the assembly of the carrier. Additionally it will gage the

adjustment for the differential bearing preload and assist in setting the primary gearing backlash. Refer to

Dana Service Manual AXSM-0057 for any additional carrier set-up information.

Models: All D170/S170 and D190/S190 Drive Axles

Wheel Differential Bearing Adjustment Kit Part Number – 513061

Kit Content: 2 - 130971 Wheel Diff. Bearing Adjuster Plate

1 - 130997 ½” –13 Threaded Rod

2 - 130998 ½” –13 Nuts

2 - HN115 Flat Washers

1 - SHAIS150 Instruction Sheet

Instructions:

1. The bearing adjustment tool is made up of a threaded rod, two nuts, two washers and two adjustment plates.

Fit one adjustment plate to the plain half threaded cup. Fit the other adjustment plate to the flange half cup.

The adjustment rings will fit into slots of the threaded bearing cups stamped adjustment ring.

1 2 3 4 5

Spicer® Axles & Brakes P/N: SHAIS150 Wheel Differential Bearing Adjustment Tool Kit Instructions Shown below is a comp

Page 2

2. Connect the adjuster plates using the threaded rod, washers and nuts. Tighten the nuts on the rod to hold the threaded cups in place. Carefully lo

Page 3

5. Use a ratchet or breaker bar and a 1 ¼” deep wall socket to turn the flange half threaded bearing cup in until the ring gear contacts the pinion (

Page 4

8. Use a rubber mallet to fully seat the threaded bearing cups. 9. With a dial indicator, c

Page 5

12. Use an impact gun to securely fasten down the (4) carrier cap fasteners. Note: Do not completely torque them down at this point.

No comments

Spicer Wheel Differential Bearing Adjustment Tool Kit Ins User Manual